To make a simple
traversing system for the turret, install a piece of 1/8" steel rod into
the base of the turret. Install the turret onto te deck and secure with a 1/8" wheel
collar.. Add a 1/8" rudder arm to the steel rod under the deck so it can be turned by
a servo, if desired.
Trim the vacuum-formed sighting dome.
Use sand paper as shown. Cement the dome in place after painting.
|
|
NOTE: This is the completed
dome with hole drilled.
Simulate the front windows and side door with .020 styrene as
shown.
The funnels are built on the bench and added
to the lower cabin top after finishing.
Cement E-1's to both sides of E-2 is
vertical.
|