Now place the main deck (D2) into place, the tops D12 D15 should form a shelf under hatch 03 as shown on SIDE 2 "View on Inside of Port Bulwark".

  The front edge of D2 should rest halfway over D18. Now glue D2 into place onto the supports strips, D12, D15 & D18 (this job is best done with a slow setting styrene adhesive, as you would get in a tube of cement.)

  Then from DC-2 cut out D10, gently trim and sand until it fits into the bow section. Glue into place onto the front half of D18 and 238's, leave aside to dry thoroughly.

Roger's Notes: When I glued the deck into position, I slid the pins into the holes to hold the deck. 


          Click on image to enlarge


          Click on image to enlarge


          Click on image to enlarge
 

          Click on image to enlarge


          Click on image to enlarge


          Click on image to enlarge
 

  After the glue had dried, I removed the pins and filled the holes with filler.


          Click on image to enlarge