  
Join the front and rear halves (S-1 & S-2) of the sheers. Note that
the inside and outside edges of the sheers form a straight line at the splice. Reinforce
the lower side of the splice with a piece of 1/8 or 1/16 ply scrap. Be sure to make a
right sheer.
Cement K-1 to K-2 for each half of the keel. Note that the inside and
outside edges form a straight line at the splice.
 |
|
Steps 3, 4 & 5. Joining the sheers and keel.
Cement the right and left keel halves
together with a slow setting epoxy. Nail, clamp or weight the keel to a flat board until
dry. Be sure the frame notches line up properly. When dry, clean any excess glue out of
the notches. Reinforce the splice with scrap ply. |
