Antenna & Steering Tubes
You will need the two 24"
nylon tubes and the 24" braided metal cable in the Hardware Bag
to complete this sub-assembly.
Make a
90'
curved bend in one end of the
last 4" of each piece of nylon tubing by heating the tubing over
a match or candle flame. Rotate the tubing while moving it back
and forth over the flame. As it becomes soft, bend the curve.
Hold it in position for about 30 seconds, until the tubing
cools.
Insert the straight end of each nylon tube into the holes on
each side of F4, F3 and F2. Start at F4 and work forward.
Position
the curved end of the antenna tube (the tube on the
left
side of the hull) against the transom, so that it
ends flush with the edge of the hatch support, as shown. Then,
use Slow CA to glue this tube to the hatch support and to the
frames it passes through.
|