Apply a film of Slow Ca to one of the attached chine logs and laminate another chine log to it. Start at the back end and work forward, pressing it into contact with the previously installed chine log. Then, laminate one chine log to the opposite side in the same manner. Repeat this procedure again to laminate one more chine log to each side of the hull.

After all of the chine logs are in place, trim them flush with the front of F1 with a razor saw.
 

The hull framework is now complete.

Hull Assembly


Repeat Instruction Step #44 to install the keel strip on the opposite side of the keel.


Using Slow CA, glue one chine log to each side of the transom and back edge of the sub-deck only. Allow the Slow CA to cure about one minute before going on.

Apply Slow CA to the notches in one side of F4, F3, F2 and to the edge of the cockpit deck. Then, starting at the back end, press the chine log into the notches and against the sub-deck.

Repeat Instruction Step #47 to glue the chine log into position on the opposite side.